Mounting Instructions: Through-bore slipring

Mounting Instructions: Through-bore slipring

Through-bore slipring

Through bore slip ring is designed with a through hole for shaft mounting.  it could be applied to transmit power, signals, RF, gas and fluid when the devices require 360° rotating.

Mounting Instructions: Through-bore slipring

Mounting instructions:

1. The slip ring rotor and stator are difficult to ensure concentricity when mounting, secure the slip ring to the rotating shaft with 4 screws.

2. Before secure the screws, please turn the slip ring firstly, after the slip ring automatically aligns the center of the shaft, then fix the screws.

3. Insert the anti-rotation bar into the anti-rotation tab to ensure a certain degree of freedom. Do not forcibly fix the anti-rotation tab, otherwise it may damage the slip ring or shorten the service life.

Notes:

1. The slip ring must not bear other objects, and the wire must not be pulled by external forces.

2. When mounting the slip ring, do not damage the wire insulation.

3. Slip rings are precision electrical components, and should be protected from dust and moisture.

4. Make sure secure the screws

5. The stator lead is far away from the rotating shaft, and the rotor lead is far away from the fixed part to avoid scratching the wires during rotation.